How to Use a Massage Gun: Timing, Heads and a Two-Minute Routine

How to use a massage gun properly: before or after training, how long on each muscle, how hard to press, which head to use, and a two-minute routine.

EVURON EditorialPublished 4 min read

Seated athlete using the EVURON ARC Pro on the shoulder after training.
Seated, arm relaxed, the device guided along the muscle. EVURON ARC Pro after training.

Use a massage gun for 30 to 60 seconds per muscle, gliding slowly along it rather than holding one spot, at a speed and pressure that feel comfortable rather than intense. Before training, keep it short and light as part of your warm-up. After training, two minutes across the muscles you worked is enough. Start with a broad, round head, and keep it off the neck, spine, bones and joints.

Before or after training?

Both work, but they do different jobs.

Before training, a massage gun is part of the warm-up, not a replacement for it. Short bursts can give a temporary increase in range of movement without reducing strength [1]. Keep it to 15 to 30 seconds per area at a light setting, then do your normal warm-up sets. The gun doesn't raise your heart rate or rehearse the movement; your warm-up still does that.

After training, it's about comfort. Massage reduces how sore and tired people feel more consistently than most recovery methods [2]. This is where most people get the most from a massage gun, and it's also the part of the session most people skip.

On rest days, an easy pass on anything that feels tight fits well alongside a walk or light mobility work.

How long, and how hard

  • 30 to 60 seconds per muscle group. Longer isn't better. No study has found a benefit to long sessions on one area, and case reports of injury involve prolonged or aggressive use [3].
  • Two minutes in total covers the main muscles from a typical session.
  • Pressure: enough that the head stays in contact and you feel the muscle respond, never so much that you hold your breath or tense up.
  • Speed: start on a low setting. Large muscles like the quads and glutes usually tolerate more; calves, forearms and the tops of the shoulders usually prefer less.

The right speed depends on how hard you press, and that changes every time you move to a new area. EVURON ARC Pro handles this for you: an integrated AI chip senses applied pressure and adjusts massage intensity and speed in real time. When you'd rather choose, eight manual levels run from 1800 to 3200 RPM.

EVURON ARC Pro held against the upper chest, the lit control face visible under the hand.
Fig. 01 Guide the device, don't drive it. EVURON ARC Pro in hand.

Which head to use

The head doesn't change what the motor does. It changes the contact area: how much surface the output is spread across.

BroadFlatNarrowForkedSoft
← Spread widerMore concentrated →
Fig. 02 Head shapes common across massage guns, and the contact each makes. A general guide, not a map of any specific gun's heads.
  • Broad, round heads spread the output. The default for quads, hamstrings and glutes. If unsure, start here.
  • Flat heads give even contact on dense areas like the front of the thigh.
  • Narrow heads concentrate the output on a small area. Use a lower speed and keep well away from bone.
  • Forked heads sit either side of a line, such as the calf or either side of the spine (never on it).
  • Soft heads suit sensitive areas.

ARC Pro includes five interchangeable heads with different contact shapes, swapped by hand without a tool.

EVURON ARC Pro laid out with its charging cable and five interchangeable massage heads.
Fig. 03 EVURON ARC Pro with its five interchangeable heads and USB-C charging cable.

A two-minute routine after training

0:000:301:001:302:00

Quads · left

40 s

Quads · right

40 s

Calves · left

20 s

Calves · right

20 s

Optional: glutes, 20 s per side, standing.

Fig. 04 Two minutes after leg day, timed. The quads take the larger share; calves need less time and less pressure.
  1. Quads, 40 seconds per leg. Seated, leg relaxed. Glide from just above the knee to the hip and back.
  2. Calves, 20 seconds per leg. Foot flat. Work the back of the lower leg, staying off the shin bone.
  3. Glutes, optional, 20 seconds per side. Standing, weight on the other leg.

For an upper-body session, swap in the chest, the back of the shoulders and the upper back either side of the spine.

The bottom line

Short and light before training, about two minutes after it, moving rather than parking, on a broad head at a comfortable setting. Do that after every session and a massage gun earns its place.

References

  1. Konrad A et al. The acute effects of a percussive massage treatment with a Hypervolt device on plantar flexor muscles' range of motion and performance. Journal of Sports Science and Medicine, 2020. Link
  2. Dupuy O et al. An evidence-based approach for choosing post-exercise recovery techniques. Frontiers in Physiology, 2018. Link
  3. Percussive massage device consumer safety risks: a critically appraised topic, 2025. Link

About this guide

EVURON Editorial

Written by the EVURON team from the published research listed above. This guide is general information, not medical advice. If you have a medical condition, an injury or pain that worries you, speak to a doctor or physiotherapist.